[Tamsta]

Originally Posted by Tamsta in help and support, was told I should place this here for the developers.

I have 2 questions please. I read the above post before I was hired . . . .it was very helpful.
This is from a chopping job - 1st - some farmers have there chopping trees double layered, meaning you can use the saw for the 1st layer, but then you have to go back and use the axe to get the 2nd layer or the job is not complete . . . . . but when you switch to the axe, you loose everything you had with the saw - - - - I read you are not supposed to change tools but can't you make it work if you are still in the same type of tool??? (hopefully that makes sense)
chopping job again - - 2nd - I was hired to finish a job someone left. Their cork trees were in a section (approx 24x24 trees) - because they had jumped around in the section I kept getting "job not complete", but couldn't get the unfinished tree to highlight with the saw. Is it possible to make a distinguishing mark for the top of the tree so that you can see what is not done when they are in sections? (ie. Peach tree has a bubble, etc) Thanks in advance for any help.
PS - They also double layer flowers which works the same way as the trees. You can use the flower harvester for the 1st layer, and the harvest pick for the 2nd.